Subaru 6MT Extension - Single Bend


This lever extension is machined from solid 5/8" diameter 303 Stainless Steel. Threads are cut into the bottom and on the top to fit the Subaru M12x1.25 shift lever and shift knobs. The center of the extension has a slight bend to allow the driver to position the knob closer to the wheel, closer to the rear, or any other orientation. Adjustment is done with an internal adjustment screw nut (tools are included for alignment).

This lever extension can be ordered in several sizes. The dimension chosen for the height is the distance the knob will move upwards. The bend will always appear near the center of the extension.

There are several available finishes including brushed stainless, flame-colored stainless, and black textured finish.

The stock STi shift knob fits onto this extension, but the alignment of the shift pattern is not guaranteed. Any one of my STi shift knobs will also fit directly onto the extension. Examples are shown in the pictures below. This setup fits any Subaru 6-speed shift lever (Stock, Cobb, Kartboy)


What you get:

  • The bent shifter extension
  • M12x1.25 jam nut to align the extension angle
  • OPTIONAL: Shift knob alignment tool. Order this tool if you are using a shift knob that has an engraving or gear pattern like the stock STi knob. Otherwise it might be crooked when you install it on the extension.
Write Your Own Review
You're reviewing:Subaru 6MT Extension - Single Bend
Your Rating
Copyright © 2022 WC Lathe Werks. All Rights Reserved.